Instructions:

Nu Fresh is a convenient answer for continuous control
of black mold and mildew growth.

These instructions are only available online

 Printed instructions and packing lists are not provided with the shipment

This is part of the green philosophy of Nu Fresh
(save a tree and all that)

_________________________

The 2 lb jar comes with a 1 oz scoop

or

Use the bottle cap to measure out the Nu Fresh.
(1 lb or 2 lb bottle caps sizes are similar) 

Both give approximately the same amount.

In the long run you will settle on an amount that works for you
so measurements are somewhat relative anyway
--------------------

The preferred method is to put a capful or two of Nu Fresh
into the detergent dispenser drawer on top of the detergent
 so you sanitize the entire dispenser system too.

Some machines will not put enough water
 through the liquid dispenser tub to dissolve the Nu Fresh completely.

if that happens

Remove the small tub in the drawer used for liquid.
and try again. Liquid first then Nu Fresh on.top.

If there still are issues

Put a level capful or two of Nu Fresh into the drum with the laundry.

---------------------

The amount you need depends on how you use your washer.
Experience is the only answer to determine the correct amount 

The problem is complicated,
 that is why it is so hard to control.

You should always try to use the smallest amount possible
 after you have the odor problem under control.

_________________________________________________________



Product Use Suggestions:

__________

Black Mold on Gasket

Nu Fresh will sanitize the gasket surface as it is used overtime.
The mold gets down into the pores of the rubber and is hard to get to.

To speed up the removal of the stuff on the gasket:
Mix 2 scoops of Nu Fresh in 1 cup of hot water.
Soak a rag in the solution
Place the wet rag on top of the gasket where the mold is.
Let it sit for at least 12 hours lightly scrubbing every now and then
to get fresh solution to the surface of the gasket.
When done, scrub off as much of the black mold and you can.
This will remove all the stuff on the surface
that would otherwise come off on the laundry

The remaining stain will disappear over time as Nu Fresh is used.

_________________________________________


If you are getting a new machine and want to start out under control:

These instructions essentially kick start the control process.

Use Nu Fresh in the first three loads at 3 capfuls per load.

Then use normally as needed.

Since you are going to get detergent film on the plumbing
as soon as you use the machine, you should put down a coating
that has a high concentration of Nu Fresh in it.

That would be the most effective way of starting out using the machine.

Even if the machine had been used already, 
a couple of Nu Fresh shock treatment flushes, should get
 you back to a clean enough surface for this to also work.

It seems the contamination level is affected more by idle time rather than loads run.

So try to do this treatment within 2-3 weeks of starting to use the machine.

___________________

However, in most cases, the machine has been in use and has had a long time
 to get the nasties growing into all the nooks and crannies of the plumbing.

Then you have to do the complete Nu Fresh shock treatment
flush procedure to get ahead of the build up of gunk.

After which you will fall into one of the categories below

__________________________________________________

If you do many loads every week, a couple of loads almost every day:
You should not need to use a lot of Nu Fresh.
Start with a capful in every load until you get the odor under control
Then back off to one load twice a week
Note how long it takes for the smell to return.
You now know your range of control,increase as necessary 

________________________


If you do more than 3 or 4 loads a week but you do them over 1 or 2 days
with the machine sitting for most of the week:
Use Nu Fresh in the first 2 loads of the week and
the last 2 loads of the week for best chance of success

________________________


If you do 3 or less loads per week:
the machine will have a long time to sit and get stinky
you will need to add Nu Fresh to every load for the best chance of success.

________________________


If the machine sits unused for longer than 7-10 days:
you will need to run an empty load with hot water
to flush out the water that is in the plumbing
before you start doing the laundry.
Then use Nu Fresh with the first 3 loads and
the last 2 loads


_________________________________________________________

Nu Fresh will have maximum effect it you use 1 capful in every load you run.
 But it usually is not necessary.

Less than half a capful in a load when you are using a regular schedule
 as above, results in poor odor control

 More than two capfuls in a load is a waste of material, unless
you are trying to remove existing mildew smell from laundry.
Then it is the correct amount...

Always rinse your hands after handling Nu Fresh.

Notice how easily it rinses off,
just like it completely rinses out of the laundry fabrics.
Yet, it sticks to the detergent that is coating the plumbing. Its Magic!
OK, its chemistry and it is explained elsewhere on this site.

Nu Fresh does not suds-up or damage clothes like the competition can.
 
Nu Fresh Deodorizer contains pure, concentrated, technical grade materials.

Nu Fresh does not contain fragrance of any kind.

Over the years there have been no reported instances
of people with sensitivities having any issues.

(our customers are smart and quite vocal so we would have heard)